• Home
  • Products  /  Accessories  /  
  • 070-7100 10mm Striker Pin

070-7100 10mm Striker Pin

Designed as a companion part for use with single rotor latches that requires a 10mm (.394") diameter striker pin and compliance to FMVSS 206 (ECE R11).

Material/Finish

  • Typical materials include 212M36 (En8M) steel (or equivalent)
  • Zinc and clear passivate

Installation

  • M12 x 1.0 thread - torque to 113 N-m (85 ft-lbs) minimum depending upon surface condition

Note: 070-7100 10mm Striker Pin is designed and tested to meet or exceed FMVSS 206 (ECE R11) safety requirements only when used with TriMark's corresponding FMVSS 206 (ECE R11) compliant latches.

Individual part dimensions are for reference only. Refer to individual part drawings for complete dimensions, specifications, and installation procedures. Engineering assistance and application drawings are available.

   

Striker Installation

  • Install striker pin in door frame
  • Close door carefully and check for interference between head of striker pin and latch components
  • Add or remove shims under striker pin as required (outside diameter of shim should be larger than outside diameter of striker pin)
  • Adjust striker pin vertically so door is not guided upward or downward while being closed
  • CHECK TO DETERMINE THAT BOTH SECONDARY AND PRIMARY LATCHING POSITIONS ARE USABLE
  • Door should be latched but not "closed" in secondary position with respect to adjacent surfaces in primary position
  • If both primary and secondary positions are not evident, readjust striker pin
  • After installation, check door alignment and door seal pressures

Typical Uses

Typical application use illustrations are organized by Industry/System and are intended to give the user some ideas for specifying a complete system using TriMark products.

Not all Industry/System applications have typical use illustrations. If a typical use illustration is not available for your specific application, please submit a technical product information request and a technical representative can assist you in selecting a product(s) solution for your specific application.

070-7100 10mm Striker Pin

Please specify search criteria:


CompareCatalog NumberTriMark NumberFinishTotal LengthStriker LengthHex SizePackagingFMVSS 206Status CodeSample RequestCAD Drawing
0707100-015-1-1-1-1-14713-127 Zinc Plate/Clear Chromate 41.5mm 19.5mm 16mm Standard YesA/A
0707100-015-1-1-1-2-14713-127-171 Zinc Plate/Clear Chromate 41.5mm 19.5mm 16mm Individually bagged YesA/A
0707100-015-2-1-1-1-14722-127 Zinc Plate/Clear Chromate 49mm 19.5mm 16mm Standard YesA/A
0707100-015-3-3-1-1-24756-127 Zinc Plate/Clear Chromate 60mm 35mm 16mm Standard NoA/A
0707100-015-3-3-2-1-24756-127-790 Zinc Plate/Clear Chromate 60mm 35mm 19mm Standard NoA/A
0707100-015-4-2-1-1-24747-127 Zinc Plate/Clear Chromate 49.5mm 27.5mm 16mm Standard NoA/A
©2024 TriMark Corporation. All rights reserved.     Privacy  •  Legal Info  •  Terms and Conditions of Sale