Designed for

• Light to medium duty doors up to 45 Kg (100 lbs.) with door seal pressures no greater than 11 Kg (25 lbs.)

Features/Benefits

• Compact size and shape; requires minimum use of door space
• Two position rotary function suitable for personnel doors for FMVSS 206 (ECE R11) applications
• Inside release options 
• Standard black finish reduces the need for secondary painting
• One variant supplied with latch plastic cover 

Available

• Versions are available to allow direct or remote actuation from exterior push button or paddle handles
• With and without on latch direct release inside levers
• With left and right variants; provides application flexibility (right hand shown)

 Material/Finish

• Inside release components: Nylon or steel with nylon knob
• Black plated steel case halves
• Cam and catch: Heat treated steel

Installation 

• Easy to install - recommended mounting fastener (2) M6 x 1.0 flat or oval head class 8.8 or better fasteners are required for FMVSS 206 (ECE R11) (not included)
• Tighten to the fastener manufacturers' recommended torque value, however, do not exceed 6 to 8 N-m (53-70 in-lbs.)
• Latch mounting plate supplied, is required to meet FMVSS 206 (ECE R11) loads

Use With

• Latch Mounting Plate (included)
• 070-7100 10mm Striker Pin

Applications of this latch may fall within the requirements of FMVSS 206 (ECE R11) and SAE J839 safety standards. These safety related requirement are dependent on door application, e.g. front and rear hinged doors, sliding doors, or hinged upward swinging doors. The entire door hardware system must be included in the design/analysis process: latch, handle, lock mechanism, cables/rods/linkages, fasteners, hinges, etc. This ensures compatibility of all components within the hardware system. If FMVSS 206 (ECE R11) is a requirement, then all of the components within the door system must comply with strength, inertia and locking requirements as specified within the Standard. Note that this product complies with FMVSS 206 (ECE R11) when tested with approved TriMark Striker Pin and Latch Mounting Plate in accordance with SAE J839 and that this product meets FMVSS 206 (ECE R11) load requirements and may be used in FMVSS 206 (ECE R11) applications pending TriMark application approval.

Individual part dimensions are for reference only. Refer to individual part dimensions for complete dimensions, specifications, and installation procedures. Engineering assistance and application drawings are available.

Caution: Product does not meet the locking requirements for FMVSS 206
(ECE R11).