060-1650 Motor Home Entrance Door Hardware

Designed for RV motor homes and fifth wheel trailer entrance doors, this product has been upgraded with a steel plunger for better security and long life. It features easy installation with through sandwich mounting, a low-profile plunger style latch which is compliant to FMVSS 206, a built-in deadbolt for additional security and is power lockable.

Designed For

Motor home entrance doors with thickness ranging from 1.39" (35.3mm) to 1.78" (45.2mm)
Different inside handle assemblies are required to facilitate the range of door thicknesses. Please identify when inquiring
Universal application - can be used in either right or left-hand doors

Features/Benefits

Inside release is low profile .940"(23.9mm) to allow for close-fitting screen doors
Paddle can be locked before door is shut and is rigid when locked
Inside assist with open bail for easy closing
Can be keyed to match other TriMark door products with KeyOne Plus for a single-key system, keyed alike or provided non-locking
Built-in deadbolt eliminates the need for add-on residential type deadbolt (deadbolt option)
Deadbolt locks into the fully extended position for true deadbolt functioning (deadbolt option)
Ability to be used with power actuation for locking
Deadbolt cylinder non-removable when locked for added security

Available

With optional built-in deadbolt
Master keyed paddle key cylinder and non-master keyed deadbolt key cylinder

Material

Housing, inside plates, handles, deadbolt, locking components including lock knobs: Die cast zinc alloy
Strike plate: Heat treated and zinc plated steel
Plunger load pins and plunger end plates: Steel

Finish

Black powder coated
Copper-nickel-chrome plated
Other finishes available upon request

Installation

#10-24 UNC mounting screws (not included). Recommended torque 10 in/lbs (1.1 N-m)
1/4-20 UNC grade 5-type fasteners for strike plate installation recommended
Supplied with gaskets already installed
Sandwich mount installation does not require any linkage rods

U.S. Patent No. 8,733,139

U.S. Design Patent No. D674,678 / D676,304

Applications of this system may fall within the requirements of FMVSS 206 (ECE R11) and SAE J839 safety standards These safety related requirements are dependent on door application, e.g. front and rear hinged doors, sliding doors, or hinged upward swinging doors. The entire door hardware system must be included in the design/analysis process: latch, handle, lock mechanism, cables/rods/linkages, fasteners, hinges, etc. This ensures compatibility of all components within the hardware system. If FMVSS 206 (ECE R11) is a requirement, then all of the components within the door system must comply with strength, inertia and locking requirements as specified within the Standard. Note that this product complies with FMVSS 206 (ECE R11) when tested in accordance with SAE J839 and that this system meets FMVSS 206 (ECE R11) loads and locking requirements and may be used in FMVSS 206 (ECE R11) applications pending TriMark application approval