050-0450 Floating Striker Rotor Latch With Remote Linkage

This robust single rotor latch is designed for medium to heavy-duty applications for off highway entrance doors. It features a vertical clearance rotor for high vibration applications and an integrated linkage that allows for remote exterior paddle actuation and direct L handle inside release and provides for ease of mounting and applications.

    Designed For

    • Medium to heavy weight doors for on or off-highway applications requiring resistance to vibration
    • Door thicknesses of 1-7/8" or greater (47.6 mm)
    • Door weights of 50-200 lbs. (23-91 kg)
    • Door seal pressures of 50-150 lbs. (suggested for best results)(23-68 kg)

    Features/Benefits

    • Allows for ± .143 (3.63) strike travel from .789 (19.91) locating dimension
    • Ideal for applications with high vibration loading and where controlled travel between the latch and strike is characteristic of the application

    Available

    • In left or right hand configurations (right hand shown)
    • With drive bar receiver parallel to striker bolt or rotated in 15° increments

    Installation

    • Four 1/4-20 UNC grade 5 mounting fasteners (not included). Tighten to the fastener manufacturers' recommended torque value, however, do not exceed 120 in-lbs. (13 N-m)
    • Maximum .312 diameter mounting holes (7.9 mm)

    Caution: Linkage does not comply with locking requirements of FMVSS 206.

    Latch & Striker Installation

    • Install striker bolt in door frame
    • Close door carefully and check for interference between head of striker bolt and latch components
    • Add or remove shims under striker bolt washer as required (outside diameter of shim should be larger than outside diameter of striker bolt washer)
    • Adjust striker bolt vertically so door is not guided upward or downward while being closed
    • CHECK TO DETERMINE THAT BOTH SECONDARY AND PRIMARY LATCHING POSITIONS ARE USABLE
    • Door should be latched but not "closed" in secondary position and latched to anticipated "closed" position with respect to adjacent surfaces in primary position
    • If both primary and secondary positions are not evident, readjust striker bolt
    • After installation, check door alignment and door seal pressures

      Latch complies with FMVSS 206 in primary and secondary latching positions when tested with approved TriMark striker bolts in accordance with SAE J839.

    Typical Uses

    Typical application use illustrations are organized by Industry/System and are intended to give the user some ideas for specifying a complete system using TriMark products.

    Not all Industry/System applications have typical use illustrations. If a typical use illustration is not available for your specific application, please submit a technical product information request and a technical representative can assist you in selecting a product(s) solution for your specific application.

    050-0450 Floating Striker Rotor Latch With Remote Linkage

    • Construction - Heavy Earthmoving

      Exterior Personnel Doors


    • Construction - Lifting and Material Handling

      Exterior Personnel Doors


    • Construction - Light Earthmoving

      Exterior Personnel Doors


    Please specify search criteria:


    ©2024 TriMark Corporation. All rights reserved.     Privacy  •  Legal Info  •  Terms and Conditions of Sale