050-1600 TriGuard重型单转子闩锁

这种闩锁专门用于中型至重型车辆的进门及后门。具有成熟

的单转轮闩锁设计，高强度8量规（4.2毫米）的前安装板及

稳固的跨式释放杆。超薄设计，装至2英寸（50.8毫米）厚的

门中，并改装升级至颇具竞争力的单转轮楔形旋转闩锁。

●超过91千克（200磅）的中型至重型车门，门密封压力为

23-60千克（50-150磅）

●与TriMark 070-0201撞栓配合使用

Designed For

Medium to heavy duty doors greater than 91 kg 200 lbs.) with door seal pressures of 23-60 kg (50-150 lbs.)
Use with TriMark 070-0201 Striker Bolt

Features/Benefits

Heavy duty modular construction -- survives in punishing environments
Can be used on retrofit applications or new surface mount vehicle construction
.550" (13.9mm) diameter striker bolt

Available

Right or left hand configurations (left hand shown)
Custom configured release levers
Other mount options (please inquire)
Heavy duty latch/striker provides rotor/cam assist to heavy doors, hinges and compensates for door sag

Material

Case halves: High strength steel
Springs: Non-corrosive stainless steel
Rotor and catch: Heat treated high strength steel with dry lube coating

Finish

Standard: RoHS compliant zinc plated, clear chromate steel components
Optional: Powder coated or CARC finish in custom colors

Installation

(3) M8 x 1.25 class 8.8 or 5/16-18 UNC grade 8 or better fasteners are recommended (not included)
Tighten to the manufacturers' recommended torque value

Patent Pending

Applications of this latch may fall within the requirements of FMVSS 206 (ECE R11) and SAE J839 safety standards. These safety related requirements are dependent on door application, e.g. front and rear hinged doors, sliding doors, or hinged upward swinging doors. The entire door hardware system must be included in the design/analysis process: latch, handle, lock mechanism, cables/rods/linkages, fasteners, hinges, etc. This ensures compatibility of all components within the hardware system. If FMVSS 206 (ECE R11) is a requirement, then all of the components within the door system must comply with strength, inertia and locking requirements as specified within the Standard. Note that this product complies with FMVSS 206 (ECE R11) when tested with approved TriMark Striker Bolts in accordance with SAE J839 and that this product meets FMVSS 206 (ECE R11) load requirements and may be used in FMVSS 206 (ECE R11) applications pending TriMark application approval