070-7100 10mm Striker Pin

Designed as a companion part for use with single rotor latches that requires a 10mm (.394") diameter striker pin and compliance to FMVSS 206 (ECE R11).

Material/Finish

Typical materials include 212M36 (En8M) steel (or equivalent)
Zinc and clear passivate

Installation

M12 x 1.0 thread - torque to 113 N-m (85 ft-lbs) minimum depending upon surface condition

Striker Installation

Install striker pin in door frame
Close door carefully and check for interference between head of striker pin and latch components
Add or remove shims under striker pin as required (outside diameter of shim should be larger than outside diameter of striker pin)
Adjust striker pin vertically so door is not guided upward or downward while being closed
CHECK TO DETERMINE THAT BOTH SECONDARY AND PRIMARY LATCHING POSITIONS ARE USABLE
Door should be latched but not "closed" in secondary position with respect to adjacent surfaces in primary position
If both primary and secondary positions are not evident, readjust striker pin
After installation, check door alignment and door seal pressures

Note: 070-7100 10mm Striker Pin is designed and tested to meet or exceed FMVSS 206 (ECE R11) safety requirements only when used with TriMark's corresponding FMVSS 206 (ECE R11) compliant latches.

Individual part dimensions are for reference only. Refer to individual part dimensions for complete dimensions, specifications, and installation procedures. Engineering assistance and application drawings are available.