090-0150 连杆

TriMark's control rods provide a connection between handles, latches, locks and linkages for remote actuation. These are available in a wide variety of options that include different lengths, diameters, offsets, retainer clips and adjustment features depending on the application requirements.

For more information on rods built to your specification, please contact TriMark at 1-800-447-0343.

Designed For

Remote connection between TriMark handles, latches, locks and linkages
Light to heavy duty applications for on or off-highway entrance and compartment doors
Applications that require the transmission of forces in tension or compression

Features/Benefits

Manufactured on a computer controlled rod bender for conformance to quality and repeat-ability
Rods can be purchased pre-installed on the latch or handle and provided as a modular system or kit

Available

In custom configurations and specific lengths to suit the application
- Multiple bend capability including compound bend angles
Available in pre-plated steel rod diameters:
- .125" (3.2mm)
- .142" (3.6mm)
- .156" (4.0mm)
- .168" (4.3mm)
- .214" (5.4mm)
- .250" (6.4mm)
- .390" (9.9mm)
Secondary operations including threading and swaging are available
TriMark has experienced engineering and technical staff available to review your product requirements and suggest the best solution for your application

Material/Finish

Low carbon steel rod material
Zinc plated, clear chromate finish

Installation

Provides for easy assembly of door hardware/system

System kits are available and include handles, latches, linkages and accessories to provide a comprehensive access solution.

Applications of this product may fall within the requirements of FMVSS 206 (ECE R11) and SAE J839 safety standards. These safety related requirements are dependent on door application, e.g. front and rear hinged doors, sliding doors, or hinged upward swinging doors. The entire door hardware system must be included in the design/analysis process: latch, handle, lock mechanism, cables/rods/linkages, fasteners, hinges, etc. This ensures compatibility of all components within the hardware system. If FMVSS 206 (ECE R11) is a requirement, then all of the components within the door system must comply with strength, inertia and locking requirements as specified with the Standard. Note that this product complies with FMVSS 206 (ECE R11) when tested in accordance with SAE J839 and that this product meets FMVSS 206 (ECE R11) locking requirements and may be used in FMVSS 206 (ECE R11) applications pending TriMark application approval.