070-7100 10mm Striker Pin

Designed as a companion part for use with single rotor latches that requires a 10mm (.394") diameter striker pin and compliance to FMVSS 206 (ECE R11).

Material/Finish

Typical materials include 212M36 (En8M) steel (or equivalent)
Zinc and clear passivate

Installation

M12 x 1.0 thread - torque to 113 N-m (85 ft-lbs) minimum depending upon surface condition

Note: 070-7100 10mm Striker Pin is designed and tested to meet or exceed FMVSS 206 (ECE R11) safety requirements only when used with TriMark's corresponding FMVSS 206 (ECE R11) compliant latches.

Individual part dimensions are for reference only. Refer to individual part drawings for complete dimensions, specifications, and installation procedures. Engineering assistance and application drawings are available.

Striker Installation

Install striker pin in door frame
Close door carefully and check for interference between head of striker pin and latch components
Add or remove shims under striker pin as required (outside diameter of shim should be larger than outside diameter of striker pin)
Adjust striker pin vertically so door is not guided upward or downward while being closed
CHECK TO DETERMINE THAT BOTH SECONDARY AND PRIMARY LATCHING POSITIONS ARE USABLE
Door should be latched but not "closed" in secondary position with respect to adjacent surfaces in primary position
If both primary and secondary positions are not evident, readjust striker pin
After installation, check door alignment and door seal pressures

Typical Uses

Typical application use illustrations are organized by Industry/System and are intended to give the user some ideas for specifying a complete system using TriMark products.

Not all Industry/System applications have typical use illustrations. If a typical use illustration is not available for your specific application, please submit a technical product information request and a technical representative can assist you in selecting a product(s) solution for your specific application.

070-7100 10mm Striker Pin

Please specify search criteria:

	Finish :
	Total Length :
	Striker Length :
	Hex Size :
	Packaging :
	FMVSS 206 :

Compare	Catalog Number	TriMark Number	Finish	Total Length	Striker Length	Hex Size	Packaging	FMVSS 206	Status Code	Sample Request	CAD Drawing
	0707100-015-1-1-1-1-1	4713-127	Zinc Plate/Clear Chromate	41.5mm	19.5mm	16mm	Standard	Yes	A/A
	0707100-015-1-1-1-2-1	4713-127-171	Zinc Plate/Clear Chromate	41.5mm	19.5mm	16mm	Individually bagged	Yes	A/A
	0707100-015-2-1-1-1-1	4722-127	Zinc Plate/Clear Chromate	49mm	19.5mm	16mm	Standard	Yes	A/A
	0707100-015-3-3-1-1-2	4756-127	Zinc Plate/Clear Chromate	60mm	35mm	16mm	Standard	No	A/A
	0707100-015-3-3-2-1-2	4756-127-790	Zinc Plate/Clear Chromate	60mm	35mm	19mm	Standard	No	A/A
	0707100-015-4-2-1-1-2	4747-127	Zinc Plate/Clear Chromate	49.5mm	27.5mm	16mm	Standard	No	A/A